• How to Determine Transom Angle
• Single
Engine Transom Layout
• Double
Engine Transom Layout
Double Engine
Bracket
Double Engine Bracket Installation
1st Mark a centerline (vertical) from top to bottom.
2nd From the keel point, go up until you get 14" of transom on both sides of your centerline. Mark a line across horizontally there.
3rd From the bottom horizontally line and go up 19", 24" or 29" (one inch short of the shaft of your engine)
20"shaft engine = 19"
25"shaft engine = 24"
30" shaft engine = 29"
4th This is where the top of your engine bracket bolts up against your transom.
* Bolts, nuts and washers must be stainless steel to avoid corrosion. *
TO PREVENT CORROSION USE ZINC
Zinc - Inside the bracket attached a wire from the engine bolt to the bolt of the zinc plate.
If you have any questions, please call us at 305-265-7922
If you have any questions, please call us at 305-265-7922
|